ASTM C179-85(1999)e1
Historical Standard: ASTM C179-85(1999)e1 Standard Test Method for Drying and Firing Linear Change of Refractory Plastic and Ramming Mix Specimens
SUPERSEDED (see Active link, below)
ASTM C179
1. Scope
1.1 This test method covers the determination of the drying shrinkage and of the combined drying and linear change of ramming and plastic refractories.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information only.
1.3 This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C113 Test Method for Reheat Change of Refractory Brick
C134 Test Methods for Size, Dimensional Measurements, and Bulk Density of Refractory Brick and Insulating Firebrick
C181 Test Method for Workability Index of Fireclay and High-Alumina Refractory Plastics
C1054 Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens
Keywords
linear change; plastic; ramming mix; refractory; shrinkage: Drying shrinkage; Heating tests--refractories; Refractories (fireclay); Refractories (plastic); Shrinkage--drying;
ICS Code
ICS Number Code 81.080 (Refractories)
DOI: 10.1520/C0179-85R99E01
ASTM International is a member of CrossRef.