ASTM A926-03
Historical Standard: ASTM A926-03 Standard Test Method for Comparing the Abrasion Resistance of Coating Materials for Corrugated Metal Pipe
SUPERSEDED (see Active link, below)
ASTM A926
1. Scope
1.1 This test method covers a procedure for comparing materials used for coating, paving and lining corrugated metal pipe by use of a bed load abrasion testing machine. The procedure attempts to simulate the effect of stone, gravel and sand carried by a stream through corrugated metal pipe.
1.2 The values stated in inch-pound units are to be regarded as standard. The SI units given in brackets are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A742/A742M Specification for Steel Sheet, Metallic Coated and Polymer Precoated for Corrugated Steel Pipe
A849 Specification for Post-Applied Coatings, Pavings, and Linings for Corrugated Steel Sewer and Drainage Pipe
A929/A929M Specification for Steel Sheet, Metallic-Coated by the Hot-Dip Process for Corrugated Steel Pipe
C131 Test Method for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine
C136 Test Method for Sieve Analysis of Fine and Coarse Aggregates
Keywords
abrasion resistance of pipe coatings; coatings abrasion; corrugated metal pipe; resistance of coating materials to abrasion; steel pipe coatings; Abrasion resistance; Coatings; Corrugated steel sewer/drain pipe; Metallic coated steel pipe; Steel pipe;
ICS Code
ICS Number Code 19.060 (Mechanical testing); 25.220.01 (Surface treatment and coating in general)
DOI: 10.1520/A0926-03
ASTM International is a member of CrossRef.