ASTM F1429-99
Historical Standard: ASTM F1429-99 Standard Test Method for Assembly Force of Plastic Underground Conduit Joints That Use Flexible Elastomeric Seals Located in the Bell
SUPERSEDED (see Active link, below)
ASTM F1429
1. Scope
1.1 This test method covers the determination of the relative force required to assemble plastic underground conduit joints that use flexible elastomeric seals located in the bell.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values stated in parentheses are provided for information purposes only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D695 Test Method for Compressive Properties of Rigid Plastics
F412 Terminology Relating to Plastic Piping Systems
Keywords
assembly force; compression tester; elastomeric seal; gasketed conduit; spigot mandrel
; Assembly force; Compression testing--plastics; Conduit joining system; Elastomeric seals/sealants; Gasketed conduit; Spigot mandrel;
ICS Code
ICS Number Code 23.040.60 (Flanges, couplings and joints)
DOI: 10.1520/F1429-99
ASTM International is a member of CrossRef.