FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Technical Bulletin
All
|
Description of BS EN 17294:2019 2019This document specifies a method for the determination of organic acids in animal feeding stuffs by Ion Chromatography with conductivity detection (IC-CD). The method is intended to be used for the determination of formic acid, lactic acid, propionic acid, citric acid, fumaric acid and malic acid as active substances in feed additives, premixtures, feed materials, compound feed and water and for acetic acid in a limited manner in the same matrices. This method determines the total extractable concentration of the above mentioned organic acids and their salts. It is advisable that the user of this standard determines the working range of the method for each organic acid. The lower limit of the working range depends on the matrix and the interferences encountered. It is advisable that a working range between 10 mg/l and 100 mg/l is achievable. The method was successfully tested in an inter-laboratory study in concentrations between 0,02 % up to 27 % of the above mentioned organic acids. NOTE Limitation occurs during simultaneous determination of high concentration of lactic acid and low concentration of acetic acid. If the ratio of concentration of lactic acid to acetic acid exceeds factor 20, the determination of acetic acid is not guaranteed. On the basis of the referred working range, sample weight and extraction volume, limits of quantification (LOQ), as calculated (Table 1) can be achievable.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|