1. Scope

1.1 This practice covers methods to determine the influence of time and stress on a material's oxygen compatibility.

1.2 This practice addresses both methods that have a foundation of experience and potential methods that have yet to be verified for validity, the latter are included to promote research and later elaboration in this practice as methods of the former type.

1.3 The values stated in SI units are to be regarded as the standard, however, all numerical values must also be cited in the systems in which they were actually measured.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 9.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D395 Test Methods for Rubber Property--Compression Set

D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

D638 Test Method for Tensile Properties of Plastics

D1349 Practice for Rubber--Standard Temperatures for Testing

D1708 Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens

D2240 Test Method for Rubber Property--Durometer Hardness

D2512 Test Method for Compatibility of Materials with Liquid Oxygen (Impact Sensitivity Threshold and Pass-Fail Techniques)

D2863 Test Method for Measuring the Minimum Oxygen Concentration to Support Candle-Like Combustion of Plastics (Oxygen Index)

D3045 Practice for Heat Aging of Plastics Without Load

D4809 Test Method for Heat of Combustion of Liquid Hydrocarbon Fuels by Bomb Calorimeter (Precision Method)

D5510 Practice for Heat Aging of Oxidatively Degradable Plastics

G63 Guide for Evaluating Nonmetallic Materials for Oxygen Service

G72 Test Method for Autogenous Ignition Temperature of Liquids and Solids in a High-Pressure Oxygen-Enriched Environment

G74 Test Method for Ignition Sensitivity of Materials to Gaseous Fluid Impact

G86 Test Method for Determining Ignition Sensitivity of Materials to Mechanical Impact in Ambient Liquid Oxygen and Pressurized Liquid and Gaseous Oxygen Environments

G125 Test Method for Measuring Liquid and Solid Material Fire Limits in Gaseous Oxidants

G126 Terminology Relating to the Compatibility and Sensitivity of Materials in Oxygen Enriched Atmospheres

Federal Standard

Keywords

aging; accelerated aging; combustion; enriched air; flammability; ignition; lifetime prediction; natural aging; oxidative degradation; oxygen; oxygen compatibility;

ICS Code

ICS Number Code 13.220.40 (Ignitability and burning behaviour of materials and products); 71.100.20 (Gases for industrial application)

DOI: 10.1520/G0114-98

ASTM International is a member of CrossRef.