ASTM E1703/E1703M-95(2005)
Historical Standard: ASTM E1703/E1703M-95(2005) Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge
SUPERSEDED (see Active link, below)
ASTM E1703 / E1703M
1. Scope
1.1 This test method describes the procedure for the measurement of the depth of the rut at a chosen location in a pavement surface using a straightedge and a gage.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E867 Terminology Relating to Vehicle-Pavement Systems
E2133 Test Method for Using a Rolling Inclinometer to Measure Longitudinal and Transverse Profiles of a Traveled Surface
Keywords
gauge ; rut; rut-depth; straightedge; Depth profiling--pavement surfaces; Gauges; Pavement surfaces; Rut-depth; Straightedge method ;
ICS Code
ICS Number Code 93.080.20 (Road construction materials)
DOI: 10.1520/E1703_E1703M-95R05
ASTM International is a member of CrossRef.