ASTM E126-05a
Historical Standard: ASTM E126-05a Standard Test Method for Inspection, Calibration, and Verification of ASTM Hydrometers
SUPERSEDED (see Active link, below)
ASTM E126
1. Scope
1.1 This test method describes the principles, apparatus, and procedures for the inspection, calibration, and verification of ASTM glass hydrometers. This test method is applicable to ASTM hydrometers and may be used for other general hydrometers of the constant-mass, variable-displacement type.
Note 1User must determine the applicability of this method for hydrometers other than ASTM hydrometers. Method studies were completed for ASTM hydrometers only and the precision and bias statements were developed using ASTM hydrometers only. References to other types of hydrometers are for user information only.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. The metric equivalents of inch-pound units may be approximate.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1265 Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method
D1298 Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
D1657 Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer
E1 Specification for ASTM Liquid-in-Glass Thermometers
E77 Test Method for Inspection and Verification of Thermometers
E100 Specification for ASTM Hydrometers
E344 Terminology Relating to Thermometry and Hydrometry
E2251 Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids
Keywords
calibration; comparators; hydrometers; reference standards; relative density; specific gravity; surface tension; verification ;
ICS Code
ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)
DOI: 10.1520/E0126-05A
ASTM International is a member of CrossRef.