5.1 This test method provides a procedure for performing laboratory tests to evaluate deflagration parameters of dusts.

5.2 The data developed by this test method may be used for the purpose of sizing deflagration vents in conjunction with the nomographs and equations published in NFPA 68 , ISO 6184/1 , or VDI 3673 .

5.3 The values obtained by this testing technique are specific to the sample tested and the method used and are not to be considered intrinsic material constants.

5.4 For dusts with low K _St -values, discrepancies have been observed between tests in 20-L and 1-m ³ chambers. A strong ignitor may overdrive a 20-L chamber, as discussed in Test Method E1515 and Refs ( 1- 3 ) . ⁷

1.1 Purpose. The purpose of this test method is to provide standard test methods for characterizing the explosibility of dust clouds in two ways, first by determining if a dust is explosible, meaning a cloud of dust dispersed in air is capable of propagating a deflagration, which could cause a flash fire or explosion; or, if explosible, determining the degree of explosibility, meaning the potential explosion hazard of a dust cloud as characterized by the dust explosibility parameters, maximum explosion pressure, P _max ; maximum rate of pressure rise, (dP/dt) _max ; and explosibility index, K _St .

1.2 Limitations. Results obtained by the application of the methods of this standard pertain only to certain combustion characteristics of dispersed dust clouds. No inference should be drawn from such results relating to the combustion characteristics of dusts in other forms or conditions (for example, ignition temperature or spark ignition energy of dust clouds, ignition properties of dust layers on hot surfaces, ignition of bulk dust in heated environments, etc.)

1.3 Use. It is intended that results obtained by application of this test be used as elements of an explosion risk assessment that takes into account other pertinent risk factors; and in the specification of explosion prevention systems (see, for example NFPA 68 , NFPA 69 , and NFPA 654 ) when used in conjunction with approved or recognized design methods by those skilled in the art.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.