ASTM E1215-93(1998)
Historical Standard: ASTM E1215-93(1998) Standard Specification for Trailers Used for Measuring Vehicular Response to Road Roughness
SUPERSEDED (see Active link, below)
ASTM E1215
1. Scope
1.1 This document specifies the design, performance, and operating features of a trailer used for measuring response to road roughness.
1.2 The specified trailer is a two-wheeled, single-axle vehicle that is towed on highways at typical traffic speeds while the relative movement between the axle and body is transduced and recorded as an indication of road roughness.
1.3 The instrumentation for sensing the movements of the trailer is not covered in this specification. One example of instrumentation is described in Test Methods E1082.
1.4 The values stated in inch-pound units are to be regarded as the standard.
1.5 The following caveat pertains only to Section 5 of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E1082 Test Method for Measurement of Vehicular Response to Traveled Surface Roughness
E1136 Specification for P195/75R14 Radial Standard Reference Test Tire
Other Document
A4082 TPC Tire Performance Criteria, Procedures and Specifications Available from General Motors Engineering Staff, GM Proving Ground, Milford, MI 48042.Keywords
trailers; vehicular response; road roughness; measuring
ICS Code
ICS Number Code 43.020 (Road vehicles in general); 93.080.20 (Road construction materials)
DOI: 10.1520/E1215-93R98
ASTM International is a member of CrossRef.