1. Scope

1.1 This standard is a compilation of test methods for evaluating properties of thermally conductive electrical insulation sheet materials to be used for dielectric applications.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See also Section 1.6.

1.5 The values stated in SI units are to be regarded as the standard.

1.6 Warning-Lethal voltages are a potential hazard during the performance of this test. It is essential that the test apparatus, and all associated equipment electrically connected to it, be properly designed and installed for safe operation. Solidly ground all electrically conductive parts which it is possible for a person to contact during the test. Provide means for use at the completion of any test to ground any parts which were at high voltage during the test or have the potential for acquiring an induced charge during the test or retaining a charge even after disconnection of the voltage source. Thoroughly instruct all operators as to the correct procedures for performing tests safely. When making high voltage tests, particularly in compressed gas or in oil, it is possible for the energy released at breakdown to be sufficient to result in fire, explosion, or rupture of the test chamber. Design test equipment, test chambers, and test specimens so as to minimize the possibility of such occurrences and to eliminate the possibility of personal injury. If the potential for fire exists, have fire suppression equipment available.

Note 1- There is no IEC publication or ISO standard equivalent to this standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

D150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation

D257 Test Methods for DC Resistance or Conductance of Insulating Materials

D374M Test Methods for Thickness of Solid Electrical Insulation (Metric)

D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

D624 Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers

D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

D883 Terminology Relating to Plastics

D1000 Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications

D1458 Test Methods for Fully Cured Silicone Rubber-Coated Glass Fabric and Tapes for Electrical Insulation

D1711 Terminology Relating to Electrical Insulation

D2240 Test Method for Rubber Property--Durometer Hardness

D5470 Test Method for Thermal Transmission Properties of Thermally Conductive Electrical Insulation Materials

D6054 Practice for Conditioning Electrical Insulating Materials for Testing

Keywords

adhesion; apparent thermal conductivity; breakdown voltage; breaking strength; dissipation factor; electrical insulation; hardness; permittivity; thermal conductivity; thermal impedance; thermally conductive; thermally conductive electrical insulation; thin electrical insulation; Adhesion--electrical insulating materials; Thermal insulating materials (electrical); Thin electrical insulating materials;

ICS Code

ICS Number Code 29.035.99 (Other insulating materials)

DOI: 10.1520/D6343-99

ASTM International is a member of CrossRef.