1. Scope

1.1 This specification covers the fabrication of new fully enclosed wirebound pallet-type wooden boxes intended for use as containers for domestic and overseas shipment of general materials and supplies, not exceeding 2500 lb [1134 kg] (see 10.1).

1.2 Wirebound pallet-type wooden box performance is dependent on its fabricated components; therefore, a variety of types, classes, and treatments reflecting varied performance are specified. This specification, however, does not cover wirebound pallet-type wooden box performance under all atmosphere, handling, shipping, and storage conditions.

1.3 If the use of other construction methods or techniques is acceptable and permitted (see 5.1.11), the resulting packaging systems shall be of equal or better performance than would result from the use of these specified material and procedures. The appropriate distribution cycle provided in Practice D 4169 can be used to develop comparative procedures and criteria.

1.4 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. See IEEE/ASTM SI 10 for conversion of units.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

American Wood Protection Association (AWPA)

ASTM Standards

D996 Terminology of Packaging and Distribution Environments

D3951 Practice for Commercial Packaging

D3953 Specification for Strapping, Flat Steel and Seals

D4169 Practice for Performance Testing of Shipping Containers and Systems

D4442 Test Methods for Direct Moisture Content Measurement of Wood and Wood-Base Materials

D4444 Test Method for Laboratory Standardization and Calibration of Hand-Held Moisture Meters

D6199 Practice for Quality of Wood Members of Containers and Pallets

D6253 Practice for Treatment and/or Marking of Wood Packaging Materials

F1667 Specification for Driven Fasteners: Nails, Spikes, and Staples

IEEE/ASTM SI 10 Standard for Use of the International System of Units (SI): The Modern Metric System

National Institute of Standards and Technology (NIST) Standard

National Motor Freight Traffic Association

Uniform Classification Committee Standard

Hardwood Plywood and Veneer Association Standard

Material Handling Industry of America (MHIA)/ANSI Standard

International Standard

U.S. Army Research, Development and Engineering Center (ARDEC)

Keywords

blank; box; fasteners; ISPM 15; nails; packaging; pallet; panelboard; shipping container; skid; staples; wire; wirebound; wood;

ICS Code

ICS Number Code 55.160 (Cases. Boxes. Crates)

DOI: 10.1520/D6254_D6254M-99

ASTM International is a member of CrossRef.