ASTM D5224-00
Historical Standard: ASTM D5224-00 Standard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds
SUPERSEDED (see Active link, below)
ASTM D5224
1. Scope
1.1 This practice covers the general principles to be followed when compression molding test specimens of thermosetting molding compounds, such as phenolics, aminoplastics, melamine phenolics, epoxies, and unsaturated polyesters.
Note 1--This standard is similar in content (but not technically equivalent) to ISO 295-1974 (E).
1.2 Molding conditions are given for amino, phenolic, and allyl molding compounds. Materials specification standards should always be consulted to determine whether the material to be molded has any special requirements.
1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ISO Standard
ISO 3167 Plastics--Multipurpose--Test SpecimensASTM Standards
D638 Test Method for Tensile Properties of Plastics
D883 Terminology Relating to Plastics
Keywords
allyl molding compound; amino molding compound; compression molding; phenolic molding compound; plastics; thermoset; Allyl molding compound; Amino molding compounds; Compression-molded plastic specimens; Dog-bone plastic specimens; Phenolic plastics; Thermosetting plastics
ICS Code
ICS Number Code 77.180 (Equipment for the metallurgical industry)
DOI: 10.1520/D5224-00
ASTM International is a member of CrossRef.