ASTM D4807-88(1999)
Historical Standard: ASTM D4807-88(1999) Standard Test Method for Sediment in Crude Oil by Membrane Filtration
SUPERSEDED (see Active link, below)
ASTM D4807
1. Scope
1.1 This test method covers the determination of sediment in crude oils by membrane filtration. This test method has been validated for crude oils with sediments up to about 0.15 mass %.
1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The accepted unit of measure for this test method is mass %.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D473 Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method (API MPMS Chapter 10.1)
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products (API MPMS Chapter 8.1)
D4177 Practice for Automatic Sampling of Petroleum and Petroleum Products (API MPMS Chapter 8.2)
D4865 Guide for Generation and Dissipation of Static Electricity in Petroleum Fuel Systems
D5854 Practice for Mixing and Handling of Liquid Samples of Petroleum and Petroleum Products (API MPMS Chapter 8.3)
API Standards
MPMSChapter10.1 Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method (ASTM Test Method )ISO Standard
ISO5272:1979 Toluene for Industrial Use--SpecificationsKeywords
crude oil; membrane filtration; sediment; Crude petroleum products; Filters/filter procedures--petroleum analysis; Heating tests--petroleum products; Homogenization efficiency of unknown mixers; Mass; Membrane filters (MF); Sediment content;
ICS Code
ICS Number Code 75.040 (Crude petroleum)
DOI: 10.1520/D4807-88R99
ASTM International is a member of CrossRef.