ASTM D4688-99
Historical Standard: ASTM D4688-99 Standard Test Method for Evaluating Structural Adhesives for Finger Jointing Lumber
SUPERSEDED (see Active link, below)
ASTM D4688
1. Scope
1.1 These test methods cover the evaluation of adhesives for finger jointing lumber used in the manufacture of structural glued laminated timber. They include tests of the tensile strength of joints; dry with no treatment, wet after one vacuum-pressure soak treatment, and wet after cyclic boil-dry treatment.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D907 Terminology of Adhesives
D2559 Specification for Adhesives for Bonded Structural Wood Products for Use Under Exterior Exposure Conditions
Keywords
billet; failure mode; finger joint; horizontal joint; structural joint; vertical joint;
ICS Code
ICS Number Code 83.180 (Adhesives)
DOI: 10.1520/D4688-99
ASTM International is a member of CrossRef.