ASTM D4024
Scope
1.1 This specification covers reinforced-thermosetting resin flanges other than contact-molded flanges. Included are requirements for materials, workmanship, performance, and dimensions.
1.2 Flanges may be produced integrally with a pipe or fitting, may be produced with a socket for adhesive bonding to a pipe or fitting, or may be of the type used in conjunction with either a
metallic or nonmetallic backup ring.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only. In cases where materials, products, or equipment are
available only in SI units, inch-pound units are omitted.
1.4 The following precautionary caveat pertains only to the test methods portion, Section 10, of this specification: This
standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health
practices and determine the applicability of regulatory limitations prior to use.
Note 1—Contact molded flanges are covered in Specification D5421 and referenced in Specification D5685.
Note 2—There is no known ISO equivalent to this standard.
Keywords
centrifugally-cast; compression-molded; filament-wound; furan; machine-made; phenolic; polyester; resin-transfer; vinyl ester ; Centrifugally cast plastic pipe--specifications; Compression-molded
plastic specimens; Extractable matter content; Fiberglass pipe--specifications; Filament-wound plastic pipe; Flanges/fittings/valves/parts (plastic)(specifications); Furan; Machine-made flanges;
Polyester plastics--specifications; Reinforced thermosetting plastics (RTP)--specifications; Reinforced thermosetting-resin pipe (RTRP)--specifications; Resin-transfer flanges; Vinyl ester
plastics
ICS Code
ICS Number Code 23.040.60 (Flanges, couplings and joints)
DOI: 10.1520/D4024-12