ASTM D3929-96e1
Historical Standard: ASTM D3929-96e1 Standard Test Method for Evaluating Stress Cracking of Plastics by Adhesives Using the Bent-Beam Method
SUPERSEDED (see Active link, below)
ASTM D3929
1. Scope
1.1 This test method describes a procedure for determining the compatibility of adhesives with plastics based on whether the adhesive causes cracking of stressed samples.
1.2 Specimen configurations and test fixture designs are given.
1.3 This test method is suitable for products in the form of sheet or strip. It can also be used on injection molded tensile specimens or flexural bars.
1.4 The valuesstated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D638 Test Method for Tensile Properties of Plastics
D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials
D907 Terminology of Adhesives
Keywords
adhesive compatibility; bent-beam; cracking; crazing; liquid adhesive; stress cracking; Tensile properties/testing--adhesive bonds; Stress cracking tests; Adhesive-bonded plastics; Adhesive compatibility; Adhesives; Bend testing; Bent-beam method; Compatibility; Crazing; Deflection; Liquid adhesives; Loading tests--adhesives; Stress--adhesives;
ICS Code
ICS Number Code 83.080.01 (Plast in general); 83.180 (Adhesives)
DOI: 10.1520/D3929-96E01
ASTM International is a member of CrossRef.