ASTM D3767-96
Historical Standard: ASTM D3767-96 Standard Practice for Rubber-Measurement of Dimensions
SUPERSEDED (see Active link, below)
ASTM D3767
1. Scope
1.1 This practice is intended for use in determining the geometrical dimensions of rubber products and specimens for physical tests. This practice describes procedures for determining length, width, thickness, diameter, and circumference. This practice does not cover sampling of materials or products, or locations where a sample is to be taken.
1.2 The values stated in either acceptable metric units or in other units shall be regarded separately as a standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any other way.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1415 Test Method for Rubber Property--International Hardness
D3183 Practice for Rubber--Preparation of Pieces for Test Purposes from Products
Keywords
dimensions; measurement; Dimensions; Geometric dimensions; Rubber property analysis; Thickness--rubber materials;
ICS Code
ICS Number Code 83.060 (Rubber)
DOI: 10.1520/D3767-96
ASTM International is a member of CrossRef.