Abstract
This specification covers material and dimensional requirements for high-density rubber cellular cushion adhered to carpet, rugs, or various substrates intended for use as a separate
underlay. However, this specification does not include requirements for burning characteristics. Material covered in this specification comprises Class A and Class B flexible, cellular,
high-density rubber. Tests for compression set, compression resistance or compression force deflection, delaminations strength, tensile strength, and accelerated aging shall be performed and
shall conform to the requirements specified.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for
its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Significance and Use
3.1 The purpose of this specification is to provide meaningful tests for rubber cellular cushion used for carpet or rug underlay.
1. Scope
1.1 This specification covers high-density cellular rubber adhered to carpet, rugs, or various substrates for use as separate underlay. It is also acceptable to use this standard as a
specification for separately blown sponge used as carpet underlay.
1.2 This specification provides material and dimensional requirements and test methods for specific properties of compression set, compression resistance or compression force deflection,
delamination strength, and accelerated aging.
Note 1 This specification does not include requirements for burning characteristics. It shall be noted that
Flammable Fabrics Act Regulations FF1-70, Standard for the Surface Flammability of Carpets and Rugs, and FF2-70, Standard for the Surface Flammability of Small Carpets and Rugs,
may be applicable for carpets and rugs with integral backing of rubber cellular cushion.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate
safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 2 There is no known ISO equivalent to this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D395 Test Methods for Rubber Property--Compression Set
D573 Test Method for Rubber--Deterioration in an Air Oven
D751 Test Methods for Coated Fabrics
D1056 Specification for Flexible Cellular Materials--Sponge or Expanded Rubber
D3574 Test Methods for Flexible Cellular Materials--Slab, Bonded, and Molded Urethane Foams
D3767 Practice for Rubber--Measurement of Dimensions
Federal Standard
Fed. Std. No. 191 Textile Test Methods, Method?5100--Breaking Strength and Elongation of Woven Cloth; Grab Method Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700
Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.
Keywords
carpet cushion specification; flexible cellular materials; rubber;
ICS Code
ICS Number Code 59.080.60 (Textile floor coverings); 83.100 (Cellular materials)
DOI: 10.1520/D3676-13
ASTM International is a member of CrossRef.
ASTM D3676