ASTM D2832-92(1999)
Historical Standard: ASTM D2832-92(1999) Standard Guide for Determining Volatile and Nonvolatile Content of Paint and Related Coatings
SUPERSEDED (see Active link, below)
ASTM D2832
1. Scope
1.1 This guide is intended to aid in the selection of the proper ASTM standard for determining the volatile and nonvolatile content of paint and related coatings.
Note 1Test methods for determining the composition of the volatile fraction are not covered by this guide.
1.2 The standards included are as follows:
Type of Coating | Section | ASTM Designation |
Aerosol coatings | 4.1 | D 3062 |
Architectural wall coatings, interior, highperformance | 4.3 | D 1644 |
Asphalt roof coatings | 4.4 | D 2823 |
Asphalt roof coatings, aluminum-pigmented | 4.5 | D 2824 |
Bitumens, emulsified | 4.6 | D 2939 |
Bleached lac varnish | 4.7 | D 1650 |
Coil coatings | 4.8 | D 1353 D 2697 |
Electrical insulation varnishes | 4.9 | D 115 |
House paints, gloss | 4.10 | D 2697 |
Industrial baking enamel | 4.10 | D 2697 |
Lacquers, clear and pigmented | 4.11 | D 1644 D 333 |
Latex paint, exterior | 4.10 | D 2697 |
Latex paint, interior | 4.10 | D 2697 |
Magnet wire enamels | 4.12 | D 3288 |
Plastics, coatings for | 4.13 | D 1644 |
Powder coatings | 4.14 | D 3451 |
Shellac varnish, orange | 4.7 | D 1650 |
Silanes, Siloxanes and Silane-Siloxane Blends | 4.18 | D 5095 |
Solvent-reducible coatings | 4.2 | D 2369 |
Traffic paints | 4.15 | D 2205 |
Varnishes | 4.16 | D 1644 |
Wall and trim enamels, interior semigloss, solvent-based | 4.17 | D 2697 |
Wall paints, flat | 4.10 | D 2697 |
Water-reducible coatings | 4.2 | D 236 |
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D115 Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
D333 Guide for Clear and Pigmented Lacquers
D1353 Test Method for Nonvolatile Matter in Volatile Solvents for Use in Paint, Varnish, Lacquer, and Related Products
D1644 Test Methods for Nonvolatile Content of Varnishes
D1650 Test Methods for Sampling and Testing Shellac Varnish
D2205 Guide for Selection of Tests for Traffic Paints
D2369 Test Method for Volatile Content of Coatings
D2697 Test Method for Volume Nonvolatile Matter in Clear or Pigmented Coatings
D2823 Specification for Asphalt Roof Coatings, Asbestos-Containing
D2824 Specification for Aluminum-Pigmented Asphalt Roof Coatings, Nonfibered, Asbestos Fibered, and Fibered without Asbestos
D2939 Test Methods for Emulsified Bitumens Used as Protective Coatings
D3062 Test Method for Solids Content of Aerosol Coatings
D3288 Test Methods for Magnet-Wire Enamels
D3451 Guide for Testing Coating Powders and Powder Coatings
D5095 Test Method for Determination of the Nonvolatile Content in Silanes, Siloxanes and Silane-Siloxane Blends Used in Masonry Water Repellent Treatments
Keywords
nonvolatile content of paints and related coatings; volatile content of paints and related coatings; Nonvolatile matter content--paints/related coatings/materials; Silanes/Siloxane; Testing methods--paints/related coatings; Volatile matter content--paints/related coatings/materials ;
ICS Code
ICS Number Code 87.040 (Paints and varnishes)
DOI: 10.1520/D2832-92R99
ASTM International is a member of CrossRef.