ASTM D2670-95(2004)
Historical Standard: ASTM D2670-95(2004) Standard Test Method for Measuring Wear Properties of Fluid Lubricants (Falex Pin and Vee Block Method)
SUPERSEDED (see Active link, below)
ASTM D2670
1. Scope
1.1 This test method covers a procedure for making a preliminary evaluation of the wear properties of fluid lubricants by means of the Falex Pin and Vee Block Lubricant Test Machine.
Note 1Certain fluid lubricants may require different test parameters depending upon their performance characteristics.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B16/B16M Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines
Keywords
pin and vee; tooth count; wear; Falex method; Lubricants (fluid); Pin and vee block; Tooth count; Vee Block method; Wear testing--petroleum products;
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D2670-95R04
ASTM International is a member of CrossRef.