ASTM D1921-06
Historical Standard: ASTM D1921-06 Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials
SUPERSEDED (see Active link, below)
Translated Standard: Russian
more info
ASTM D1921
1. Scope
1.1 These test methods cover the measurement of the particle size of plastic materials in the powdered, granular, or pelleted forms in which they are commonly supplied. As these test methods utilize dry sieving, the lower limit of measurement is considered to be about 38 m (No. 400 sieve). For smaller particle sizes, sedimentation test methods are recommended.
1.2 Two test methods are described:
1.2.1 Test Method AThis test method uses multiple sieves selected to span the particle size of the material. This method is used to determine the mean particle diameter and particle size distribution.
1.2.2 Test Method BThis test method is an abbreviated version of Test Method A conducted with a few specific sieves. This test method determines 'percent passing' or 'percent retained' on a given sieve. Test Method B is applicable to materials which do not have a normal particle size distribution such as pellets and cubes.
1.3 The values stated in SI units shall be considered standard for dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
There is no technically equivalent ISO standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
particle size analysis-plastics; plastics, powder, granular, and pellet, dry-sieve method; plastics (general); particle size, test; sieve analysis-dry;
ICS Code
ICS Number Code 19.120 (Particle size analysis. Sieving)
DOI: 10.1520/D1921-06
ASTM International is a member of CrossRef.