ASTM B233-97(2003)e1
Historical Standard: ASTM B233-97(2003)e1 Standard Specification for Aluminum 1350 Drawing Stock for Electrical Purposes
SUPERSEDED (see Active link, below)
ASTM B233
1. Scope
1.1 This specification covers aluminum 1350 drawing stock 0.375 in. (9.52 mm) to 1.000 in. (25.40 mm) in diameter, in the tempers shown in Table 1, for drawing into wire for electrical conductors (Explanatory Note 1 and Note 2).
1.2 The SI values of density and resistivity are to be regarded as the standard. For all other properties the inch-pound values are to be regarded as standard and the SI units may be approximate.
Note 1Prior to 1975, aluminum 1350 was designated as EC aluminum.
Note 2The aluminum and temper designations conform to ANSI H35.1. Aluminum 1350 corresponds to unified numbering system A91350 in accordance with Practice E 527.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B193 Test Method for Resistivity of Electrical Conductor Materials
B354 Terminology Relating to Uninsulated Metallic Electrical Conductors
B557 Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products
B830 Specification for Uniform Test Methods and Frequency
E34 Test Methods for Chemical Analysis of Aluminum and Aluminum-Base Alloys
E55 Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition
E227 Test Method for Optical Emission Spectrometric Analysis of Aluminum and Aluminum Alloys by the Point-to-Plane Technique
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
American National Standard
ANSIH35.1 Alloy and Temper Designation Systems for AluminumKeywords
aluminum; aluminum drawing stock; aluminum wire; drawing stock; wire;
ICS Code
ICS Number Code 77.150.10 (Aluminium products)
DOI: 10.1520/B0233-97R03E01
ASTM International is a member of CrossRef.