ASTM B183-79(1997)
Historical Standard: ASTM B183-79(1997) Standard Practice for Preparation of Low-Carbon Steel for Electroplating
SUPERSEDED (see Active link, below)
ASTM B183
1. Scope
1.1 This practice is intended as an aid to electroplaters in setting up a suitable cleaning cycle preparatory to electroplating of low-carbon steel (Note 1) containing less than 0.35 mass% of carbon and to indicate some of the precautions that must be taken to maintain this cycle in good operating condition.
Note 1-The preparation of high-carbon steel for electroplating is covered in Practice B242.1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B242 Guide for Preparation of High-Carbon Steel for Electroplating
B322 Guide for Cleaning Metals Prior to Electroplating
Keywords
Carbon steel; Electroplated steel coatings; Low-carbon steel; Specimen preparation (general)--electroplating; Steel--electroplating
ICS Code
ICS Number Code 25.220.10 (Surface preparation)
DOI: 10.1520/B0183-79R97
ASTM International is a member of CrossRef.