ASTM A835/A835M-84(2010)
Historical Standard: ASTM A835/A835M-84(2010) Standard Specification for Sizes of Ferroalloys and Alloy Additives
SUPERSEDED (see Active link, below)
ASTM A835 / A835M
1. Scope
1.1 This specification covers standard nominal sizes and size tolerances of screened ferroalloy and alloy additive products. This specification provides a range of sizes as referenced in all ASTM specifications for ferroalloys and alloy additives.
1.2 The sizes and tolerances allow for varying degrees of friability upon receipt of material since some attrition may be expected in transit, storage, and handling.
1.3 Specifications of sieve sizes used to define tolerances are listed in Specification E11 . Representative procedures for evaluation of each lot are described in Methods A610 . Refer to Appendix X1 for applicable sieve designations (see Table X1.1).
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A610 Test Methods for Sampling and Testing Ferroalloys for Determination of Size
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
Keywords
Classification (standards)--metals/alloys; Ferroalloys; Ferrous metals/alloys--specifications; Size/size distribution analysis; Stainless steel alloying additives; Tolerances--metals/alloys;
ICS Code
ICS Number Code 77.100 (Ferroalloys)
DOI: 10.1520/A0835_A0835M-84R10
ASTM International is a member of CrossRef.