ASTM F1308-98
Historical Standard: ASTM F1308-98 Standard Test Method for Quantitating Volatile Extractables in Microwave Susceptors Used for Food Products
SUPERSEDED (see Active link, below)
ASTM F1308
1. Scope
1.1 This test method covers complete microwave susceptors.
1.2 This test method covers a procedure for quantitating volatile compounds whose identity has been established and which are evolved when a microwave susceptor sample is tested under simulated use conditions.
1.3 This test method was collaboratively evaluated with a variety of volatile compounds (see statistical evaluation). For compounds other than those evaluated, the analyst should determine the sensitivity and reproducibility of the method by carrying out appropriate spike and recovery studies. The analyst is referred to Practice E260 for guidance.
1.4 For purposes of verifying the identity of or identifying unknown volatile compounds, the analyst is encouraged to incorporate techniques such as gas chromatography/mass spectroscopy, gas chromatography/infrared spectroscopy, or other techniques in conjunction with this test method.
1.5 A sensitivity level of approximately 0.025 [mu]g/in. is achievable for the compounds studied in Table 1. Where other compounds are being quantitated and uncertainty exists over method sensitivity, the analyst is referred to Practice E260 for procedures on determining sensitivity of chromatographic methods.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety hazards statements are given in 9.1, 9.4, 11.1, and 11.7.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E260 Practice for Packed Column Gas Chromatography
F1317 Test Method for Calibration of Microwave Ovens
TAPPI Standards
TIS808 Equilibrium relative humidities over saturated salt solutionsKeywords
extractables, volatile, quantitation, in microwave susceptors; fluoroptic thermometry; gas chromatography, static headspace; microwave susceptors; microwave suseptors, volatile extractables in; susceptors, microwave; volatile extractables, quantitation, in microwave susceptors; Calibration--food service equipment; Extractives (volatile/nonvolatile); Gas chromatography (GC); Microwave frequencies; Quantitative analysis/measurement; Susceptor/food interface temperatures; Volatile extractables; Volatile matter content; Volatile organic compounds (VOC)
ICS Code
ICS Number Code 67.250 (Materials and articles in contact with foodstuff and water)
DOI: 10.1520/F1308-98
ASTM International is a member of CrossRef.