eLibrary >
BS ISO 9361-1:2014 Indexable inserts for cutting tools. Ceramic inserts with rounded corners - Dimensions of inserts without fixing hole >
Expand All
TOC Search:
BS ISO 9361-1:2014 Indexable inserts for cutting tools. Ceramic inserts with rounded corners - Dimensions of inserts without fixing hole, 2014
- Section sec_1
- Section sec_2
- Section sec_3
- Section sec_4
- Section sec_5
- Section sec_5.1
- Section sec_5.2
- Figure fig_1
- Figure fig_2
- Section sec_6
- Section sec_6.1
- Section sec_6.2
- Section sec_7
- Section sec_8
- Table tab_1
- Section sec_8.1
- Figure fig_3
- Figure fig_4
- Table tab_2
- Section sec_8.2
- Figure fig_5
- Figure fig_6
- Table tab_3
- Section sec_8.3
- Figure fig_7
- Table tab_4
- Section sec_8.4
- Figure fig_8
- Table tab_5
- Section sec_8.5
- Figure fig_9
- Table tab_6
- Annex sec_A
- Annex sec_A.1
- Figure fig_A.1
- Annex sec_A.2
- Figure fig_A.2
- Annex sec_A.3
- Figure fig_A.3
- Annex sec_A.4
- Annex sec_B
- Table tab_B.1
- Annex sec_C
- Table tab_C.1
- Reference ref_1
- Reference ref_2
- Reference ref_3
- Reference ref_4
- Reference ref_5
- Reference ref_6
- Reference ref_7
- Foreword
- 1 Scope
- 2 Normative references
- 3 Types of inserts
- 4 Tolerances
- 5 Cutting edge
- 5.1 Cutting edge condition
- 5.2 Additional information
- 6 Designation and marking
- 6.1 Designation
- 6.2 Marking
- 7 Measurement
- 8 Recommended dimensions
- 8.1 Triangular inserts
- 8.2 Square inserts
- 8.3 Rhombic inserts with 80° included angle
- 8.4 Rhombic inserts with 55° included angle
- 8.5 Round inserts
- Annex A (normative) Method of measurement of “m” dimension
- Annex B (normative) Range of sizes of inserts with rounded corners, without fixing hole, having shapes covered by this part of ISO 9361
- Annex C (informative) Relationship between designations in ISO 9361-1 and ISO 13399-series
- Bibliography [Go to Page]