ASTM F2084/F2084M-01(2007)e2
Historical Standard: ASTM F2084/F2084M-01(2007)e2 Standard Guide for Collecting Containment Boom Performance Data in Controlled Environments
SUPERSEDED (see Active link, below)
ASTM F2084 / F2084M
1. Scope
1.1 This guide covers the evaluation of the effectiveness of full-scale oil spill containment booms in a controlled test facility.
1.2 This guide involves the use of specific test oils that may be considered hazardous materials. It is the responsibility of the user of this guide to procure and abide by the necessary permits for disposal of the used test oil.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D97 Test Method for Pour Point of Petroleum Products
D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)
D971 Test Method for Interfacial Tension of Oil Against Water by the Ring Method
D1298 Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
D1796 Test Method for Water and Sediment in Fuel Oils by the Centrifuge Method (Laboratory Procedure)
D2983 Test Method for Low-Temperature Viscosity of Lubricants Measured by Brookfield Viscometer
D4007 Test Method for Water and Sediment in Crude Oil by the Centrifuge Method (Laboratory Procedure)
D4052 Test Method for Density, Relative Density, and API Gravity of Liquids by Digital Density Meter
F631 Guide for Collecting Skimmer Performance Data in Controlled Environments
F818 Terminology Relating to Spill Response Barriers
Keywords
oil spill; containment; test facility; boom performance; hazardous materials;
ICS Code
ICS Number Code 13.030.40 (Installations and equipment for waste disposal and treatment)
DOI: 10.1520/F2084_F2084M-01R07E02
ASTM International is a member of CrossRef.