ASTM F1444-00(2004)
Historical Standard: ASTM F1444-00(2004) Standard Test Method for Determining Dynamic Thermal Response of Direct Thermal Paper-Label Printer Method
SUPERSEDED (see Active link, below)
ASTM F1444
1. Scope
1.1 This test method covers the thermal response of direct thermal papers to determine uniformity within and between lots. This test method may also be used to test direct thermal products other than paper.
1.2 The Hobart 18VP Thermal Label Printer described in this test method may be used for specification acceptance, product development or research applications, or both, and manufacturing control.
1.3 Although a specific manufacturer has been identified for this equipment, any thermal label printer with equivalent signal output capabilities and sample size requirements would be suitable.
1.4 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses, are for information only.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note- Warning -This test method requires making power adjustments and trigger printing while the protective cover is off, thereby exposing the user to electrical hazards.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ANSI Standards
IT 2.171995Keywords
direct thermal paper; dynamic thermal response; dynamic thermal response curve; thermal printer; thermal sensitivity; Copy materials/products--electrostatic; Direct thermal imaging; Dynamic thermal response; Thermal transfer imaging systems;
ICS Code
ICS Number Code 37.100.10 (Reproduction equipment)
DOI: 10.1520/F1444-00R04
ASTM International is a member of CrossRef.