ASTM D6114/D6114M
Scope
1.1 This specification covers asphalt-rubber binder consisting of a blend of asphalt binder, ground recycled tire (that is, vulcanized) rubber, and other
additives, as needed, for use as binder in pavement construction. The rubber shall be blended and interacted in the hot asphalt binder sufficiently to cause swelling of the rubber particles
prior to use.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact
equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and
figures) shall not be considered as requirements of the standard.
1.4 Since a precision estimate for this standard has not been developed, the test method is to be used for research and informational purposes only.
Therefore, this standard should not be used for acceptance or rejection of a material for purchasing purposes.
Note 1: The quality of the results produced by this standard are dependent on the competence
of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with
Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of
Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.
1.5 The following precautionary caveat pertains to the test method
portions only, Sections 4 and 5 of this specification: This standard does not purport to address all of the
safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the
applicability of regulatory limitations prior to use. Specific precautionary statements are given in 4.3.2.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on
Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
asphalt; asphalt-rubber; crumb rubber modified (CRM); ground tire rubber (GTR); rubber; wet process;
ICS Code
ICS Number Code 93.080.20 (Road construction materials)
DOI: 10.1520/D6114_D6114M-19R23