1. Scope

1.1 This test method covers procedures for preparing and testing asphalt concrete specimens for the purpose of measuring the effect of water on the tensile strength of the paving mixture. This test method is applicable to dense mixtures such as those appearing in the Table for Composition of Bituminous Paving Mixtures in Specification D 3515. This test method can be used to evaluate the effect of moisture with or without antistripping additives including liquids and pulverulent solids such as hydrated lime or portland cement.

1.2 The values stated in either SI units or inch-pound units in parentheses shall be regarded separately as standard. The values in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D979 Practice for Sampling Bituminous Paving Mixtures

D1074 Test Method for Compressive Strength of Bituminous Mixtures

D1561 Practice for Preparation of Bituminous Mixture Test Specimens by Means of California Kneading Compactor

D2041 Test Method for Theoretical Maximum Specific Gravity and Density of Bituminous Paving Mixtures

D2726 Test Method for Bulk Specific Gravity and Density of Non-Absorptive Compacted Bituminous Mixtures

D3203 Test Method for Percent Air Voids in Compacted Dense and Open Bituminous Paving Mixtures

D3387 Test Method for Compaction and Shear Properties of Bituminous Mixtures by Means of the U.S. Corps of Engineers Gyratory Testing Machine (GTM)

D3496 Practice for Preparation of Bituminous Mixture Specimens for Dynamic Modulus Testing

D3515 Specification for Hot-Mixed, Hot-Laid Bituminous Paving Mixtures

D3549 Test Method for Thickness or Height of Compacted Bituminous Paving Mixture Specimens

D3665 Practice for Random Sampling of Construction Materials

D4013 Practice for Preparation of Test Specimens of Bituminous Mixtures by Means of Gyratory Shear Compactor

D4123 Test Method for Indirect Tension Test for Resilient Modulus of Bituminous Mixtures

D6926 Practice for Preparation of Bituminous Specimens Using Marshall Apparatus

Keywords

antistripping additives; asphalt concrete paving mixtures; moisture; tensile strength; water; Additive dosage; Antistripping asphalt additives; Asphalt paving mixtures; Concrete admixtures; Effectiveness testing; Moisture analysis--asphalt/bituminous materials; Pavement surfaces; Plant-produced concrete mixtures; Tensile properties/testing--concrete; Water analysis;

ICS Code

ICS Number Code 93.080.20 (Road construction materials)

DOI: 10.1520/D4867_D4867M-04

ASTM International is a member of CrossRef.