ASTM E2029-99(2004)
Historical Standard: ASTM E2029-99(2004) Standard Test Method for Volumetric and Mass Flow Rate Measurement in a Duct Using Tracer Gas Dilution
SUPERSEDED (see Active link, below)
ASTM E2029
1. Scope
1.1 This test method describes the measurement of the volumetric and mass flow rate of a gas stream within a duct, stack, pipe, mine tunnel, or flue using a tracer gas dilution technique. For editorial convenience all references in the text will be to a duct, but it should be understood that this could refer equally well to a stack, pipe, mine tunnel, or flue. This test method is limited to those applications where the gas stream and the tracer gas can be treated as ideal gases at the conditions of the measurement. In this test method, the gas stream will be referred as air, though it could be any other gas that exhibits ideal gas law behavior.
1.2 This test method is not restricted to any particular tracer gas although experimental experience has shown that certain gases are used more readily than others as suitable tracer gases. It is preferable that the tracer gas not be a natural component of the gas stream.
1.3 Use of this test method requires a knowledge of the principles of gas analysis and instrumentation. Correct use of the formulas presented here requires consistent use of units.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E631 Terminology of Building Constructions
ANSI/ASME Standards
ANSI/ASME TC 19.1&nd Measurement Uncertainty: Instrument ApparatusKeywords
ducts; flow rate; mass flow; stacks; tracer gas; volumetric flow: Flow and flow rate--airflow systems/devices; Gas streams; Mass flow; Tracer dilution method; Volumetric measurement;
ICS Code
ICS Number Code 13.040.01 (Air quality in general)
DOI: 10.1520/E2029-99R04
ASTM International is a member of CrossRef.