ASTM D6070-98
Historical Standard: ASTM D6070-98 Standard Test Methods for Physical Properties of Smooth-Wall, Coilable, Polyethylene (PE) Conduit (Duct) for Preassembled Wire and Cable
SUPERSEDED (see Active link, below)
ASTM D6070
1. Scope
1.1 These test methods cover procedures for determining the environmental performance properties of smooth-wall, coilable, medium-density and high-density polyethylene (MDPE and HDPE) conduit (duct) for preassembled wire and cable.
1.2 The values stated in inch-pound units are the standard, except in cases where SI units are more appropriate. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D2444 Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
Keywords
compression and recovery; conduit; duct; high-density polyethylene; impact test; medium-density polyethylene; Compression testing--electrical insulating materials; Compression testing--plastics; Conduits; HDPE (high-density polyethylene); MDPE (medium density polyethylene); Polyethylene (PE) electrical insulation; Preassembled wire and cable;
ICS Code
ICS Number Code 29.120.10 (Conduits for electrical purposes); 83.080.20 (Thermoplastic materials)
DOI: 10.1520/D6070-98
ASTM International is a member of CrossRef.