ASTM D4537-91(1996)
Historical Standard: ASTM D4537-91(1996) Standard Guide for Establishing Procedures to Qualify and Certify Inspection Personnel for Coating Work in Nuclear Facilities
SUPERSEDED (see Active link, below)
ASTM D4537
1. Scope
1.1 This guide delineates the requirements for development of procedures for the qualification of personnel who perform inspection of coating work. These activities are accomplished to verify conformance to specified requirements for nuclear facility coatings work whose satisfactory performance is required in order not to compromise systems used to mitigate the consequences of postulated accidents.
1.2 This guide provides a uniform interpretation of the requirements in ANSI/ASME N45.2.6-1978 for the inspection of coating work in nuclear facilities.
1.3 This guide meets the intent of ANSI/ASME NQA-1.
1.4 It is the intent of this guide to provide a recommended basis for qualification, not to mandate a singular basis for all qualifications. Variations or simplifications of the qualifications described in this guide are appropriate for special coating work outside of safety-related areas.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D4538 Terminology Relating to Protective Coating and Lining Work for Power Generation Facilities
D5144 Guide for Use of Protective Coating Standards in Nuclear Power Plants
D5498 Guide for Developing a Training Program for Personnel Performing Coating and Lining Work Inspection for Nuclear Facilities
ANSI/ASME Standards
ANSI/ASMENQA-1 Quality Assurance Program Requirements for Nuclear FacilitiesKeywords
coating and lining work inspection; individuals certified to perform Level I, II, and III inspection ; Inspection--coating applications; Inspection personnel/inspectors; Nuclear coating work inspection; Nuclear reactor vessels--qualifications for painters; Procedures; Qualifications--nuclear facilities;
ICS Code
ICS Number Code 87.020 (Paint coating processes)
DOI: 10.1520/D4537-91R96
ASTM International is a member of CrossRef.