ASTM D3115-95(2000)
Historical Standard: ASTM D3115-95(2000) Standard Test Method for Explosive Reactivity of Lubricants with Aerospace Alloys Under High Shear
SUPERSEDED (see Active link, below)
ASTM D3115
1. Scope
1.1 This test method is used to evaluate for explosive reactivity of various lubricants in the presence of aerospace alloys under high shear conditions.
1.2 The values stated in SI units are to be regarded as the standard. In cases where materials, products, or equipment are available in inch-pound units only, SI units are omitted.
1.3 This standard should be used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions and should not be used to describe or appraise the fire-hazard or fire-risk of materials, products, or assemblies under actual fire conditions. However, results of the test may be used as elements of a fire-hazard assessment or a fire-risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard or fire risk of a particular end use.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B209 Specification for Aluminum and Aluminum-Alloy Sheet and Plate
B221 Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes
ANSI Standard
B46.1 Surface Texture Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
aerospace alloys; explosive reactivity; lubricants; reactivity; shear; Aerospace fluids/propellants; Aluminum content--petroleum products; Explosions/explosives; High modulus fibrous composites; Lubricants (fluid); Magnesium content--petroleum products; Nonferrous metals/alloys; Pressure testing--petroleum products; Reactivity; Shear testing--petroleum products; Spark-source mass spectrometry;
ICS Code
ICS Number Code 49.025.99 (Other materials)
DOI: 10.1520/D3115-95R00
ASTM International is a member of CrossRef.