ASTM C29/C29M-97
Historical Standard: ASTM C29/C29M-97 Standard Test Method for Bulk Density (Unit Weight) and Voids in Aggregate
SUPERSEDED (see Active link, below)
ASTM C29 / C29M
1. Scope
1.1 This test method covers the determination of bulk density ('unit weight') of aggregate in a compacted or loose condition and calculated voids in fine, coarse, or mixed aggregates based on the same determination. This test method is applicable to aggregates not exceeding 6 in. (150 mm) in nominal maximum size.
Note 1-Unit weight is the traditional terminology used to describe the property determined by this test method, which is weight per unit volume (more correctly, mass per unit volume or density).
1.2 The values stated in either inch-pound units or acceptable metric units are to be regarded separately as standard, as appropriate for a specification with which this test method is used. An exception is with regard to sieve sizes and nominal size of aggregate, in which the metric values are the standard as stated in Specification E11. Within the text, metric units are shown in parentheses. The values stated in each system may not be exact equivalents; therefore each system must be used independently of the other, without combining values in any way.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C125 Terminology Relating to Concrete and Concrete Aggregates
C127 Test Method for Density, Relative Density (Specific Gravity), and Absorption of Coarse Aggregate
C128 Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate
C138/C138M Test Method for Density (Unit Weight), Yield, and Air Content (Gravimetric) of Concrete
C670 Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
C702 Practice for Reducing Samples of Aggregate to Testing Size
D75 Practice for Sampling Aggregates
D123 Terminology Relating to Textiles
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
Keywords
aggregates; bulk density; coarse aggregate; density; fine aggregate; unit weight; voids in aggregates; Coarse aggregate; Fine aggregate; Unit weight; Void content; Weight--concrete/aggregates;
ICS Code
ICS Number Code 19.060 (Mechanical testing)
DOI: 10.1520/C0029_C0029M-97
ASTM International is a member of CrossRef.