ASTM C113-93(1998)
Historical Standard: ASTM C113-93(1998) Standard Test Method for Reheat Change of Refractory Brick
SUPERSEDED (see Active link, below)
ASTM C113
1. Scope
1.1 This test method covers the determination of the permanent linear change of refractory brick when heated under prescribed conditions.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Note 1-Test methods incorporating additional provisions pertinent to specific refractory materials are given in the following Test Methods: C179, C210, C436, and C605.1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C134 Test Methods for Size, Dimensional Measurements, and Bulk Density of Refractory Brick and Insulating Firebrick
C179 Test Method for Drying and Firing Linear Change of Refractory Plastic and Ramming Mix Specimens
C210 Test Method for Reheat Change of Insulating Firebrick
C605 Test Method for Reheat Change of Fireclay Nozzles and Sleeves
E230 Specification and Temperature-Electromotive Force (EMF) Tables for Standardized Thermocouples
Keywords
heating schedule; refractory brick; reheat change; temperature measurements; test atmosphere; Heating tests--refractories; Linear changes/linearity; Refractories (bricks and shapes); Reheat change;
ICS Code
ICS Number Code 81.080 (Refractories)
DOI: 10.1520/C0113-93R98
ASTM International is a member of CrossRef.