ASTM A394-05e1
Historical Standard: ASTM A394-05e1 Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare
SUPERSEDED (see Active link, below)
ASTM A394
1. Scope
1.1 This specification covers the chemical and mechanical requirements of hexagon and square-head zinc-coated steel bolts and atmospheric corrosion-resistant bolts, in nominal thread diameters of 1/2, 5/8, 3/4, 7/8 and 1 in. for use in the construction of transmission towers, substations, and similar steel structures. The various types of bolts covered in this specification are:
1.1.1 Type 0 Hot-dip zinc-coated bolts made of low or medium carbon steel.
1.1.2 Type 1 Hot dip zinc-coated bolts made of medium carbon steel, quenched and tempered.
1.1.3 Type 2 Withdrawn in 2005.
1.1.4 Type 3 Bare (uncoated), quenched and tempered bolts made of weathering steel.
1.2 Annex A1 of this specification covers hot-dipzinc-coated steel ladder bolts, step bolts, and support-equipment bolts.
1.3 Nuts and washers that are supplied under this specifcation that are hot-dip zinc coated shall be in accordance with 4.4.
1.4 Terms used in this specification are defined in Terminology F1789.
1.5 The values stated in ince-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.6 The following safety hazards caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A563 Specification for Carbon and Alloy Steel Nuts
D3951 Practice for Commercial Packaging
F436 Specification for Hardened Steel Washers
F606 Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
F788/F788M Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series
F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
F1789 Terminology for F16 Mechanical Fasteners
F2329 Specification for Zinc Coating, Hot-Dip, Requirements for Application to Carbon and Alloy Steel Bolts, Screws, Washers, Nuts, and Special Threaded Fasteners
G101 Guide for Estimating the Atmospheric Corrosion Resistance of Low-Alloy Steels
Keywords
bolts; carbon steel; steel; transmission tower; weathering steel
; Bolting materials; Hexagon-head bolts; Hot-dip (galvanized) coatings--specifications; Square-head bolts; Steel bolting materials--specifications; Structural steel (SS) bolting
materials--specifications; Substations; Transmission systems; Weathering steels;
ICS Code
ICS Number Code 21.060.10 (Bolts, screws, studs); 29.240.20 (Power transmission and distribution lines)
DOI: 10.1520/A0394-05E01
ASTM International is a member of CrossRef.