Abstract

This guide covers performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems. This guide also covers vessel-based spray systems employing single-point spray nozzles. Oil spill dispersant spray equipment shall conform to the minimum performance requirements such as target dosage, dispersant flow or injection rate determination, droplet size distribution, and maximum delivery variation over spray switch. Materials used in the spray systems shall be corrosion-resistant to salt water and shall be able to be used or stored at extreme temperatures. Performance data shall be provided to user, including information such as dilute versus neat application, dosage chart, accuracy of data, nozzles and pumps, and operational manual.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This guide covers performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems. This guide is not intended to be restrictive to a specific configuration.

1.2 This guide covers vessel-based spray systems employing single-point spray nozzles, including designs that have been based on or evolved from fire-monitor systems, and is not fully applicable to other systems such as spray boom/nozzle or aircraft systems.

1.3 This guide is one of five related to dispersant application systems. The other four guides cover the design of boom and nozzle systems, spray system calibration, spray deposition measurements, and use of the systems. Familiarity with all five guides (listed in 2.1) is recommended.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

F1413 Guide for Oil Spill Dispersant Application Equipment: Boom and Nozzle Systems

F1460 Practice for Calibrating Oil Spill Dispersant Application Equipment Boom and Nozzle Systems

F1737 Guide for Use of Oil Spill Dispersant Application Equipment During Spill Response: Boom and Nozzle Systems

F1738 Test Method for Determination of Deposition of Aerially Applied Oil Spill Dispersants

Keywords

dispersant application; dispersants; dispersant spray equipment; fire monitor; oil spill chemicals; oil spill dispersants; oil spill treating agents; single-point spray nozzles: Dispersant applications; Oil spill dispersants; Single-point spray systems;

ICS Code

ICS Number Code 13.020.40 (Pollution, pollution control and conservation)

DOI: 10.1520/F2465_F2465M-05R11E01

ASTM International is a member of CrossRef.

ASTM F2465 / F2465M