ASTM F2162-01e2
Historical Standard: ASTM F2162-01e2 Standard Specification for Bearing, Roller, Needle: Drawn Outer Ring, Full Complement, Without Inner Ring, Open and Closed End, Standard Type
SUPERSEDED (see Active link, below)
ASTM F2162
1. Scope
1.1 This specification covers standard-type needle roller bearings having drawn outer rings, full complement, without inner rings, with either open or closed ends.
1.2 The use of recycled materials that meet the requirements of the applicable material specification without jeopardizing the intended use of the item is encouraged.
1.3 The inner rings specified in this specification are not intended for use in flight critical systems of aircraft.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
Note 1This specification was originally developed by the Department of Defense and maintained by the Defense Supply Center Richmond. It is intended to replicate the requirements of MS 17130.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASME Standard
ASMEB46.1 Surface Texture Surface Roughness, Waviness, and Lay Available from Global Engineering Documents, 15 Inverness Way, East Englewood, CO 80112-5704, http://www.global.ihs.com.SAE Standard
SAEJ-404 Chemical Composition of SAE Alloy Steels Available from Society of Automotive Engineers (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.Military Standard
MIL-STD-130 Identification Marking of US Military Property Available from USA Information Systems, 1092 Laskin Rd., Ste. 208, Virginia Beach, VA 23451.American Bearing Manufacturers Association (ABMA) Standard
STD4 Tolerance Definitions and Gauging Practices For Ball and Roller Bearings Available from the American Bearing Manufacturers Association, 1200 19th St. NW, Ste. 300, Washington, DC 20036-2401.ISO Standards
ISO1132 Rolling Bearings--Tolerances--DefinitionsASTM Standards
E18 Test Methods for Rockwell Hardness of Metallic Materials
E140 Hardness Conversion Tables for Metals Relationship Among Brinell Hardness, Vickers Hardness, Rockwell Hardness, Superficial Hardness, Knoop Hardness, and Scleroscope Hardness
E384 Test Method for Knoop and Vickers Hardness of Materials
F2163 Specification for Ring, Bearing, Inner: for Needle Roller Bearing With Drawn Outer Ring
Keywords
drawn outer ring; full complement bearing; needle bearing; MS17131; roller bearing; Ball/roller bearings--specifications; Basic dynamic load rating; Basic static load rating; Drawn outer ring; Full complement bearing; Inner ring; Needle bearing; Needle roller bearing; Roller bearings;
ICS Code
ICS Number Code 21.100.20 (Rolling bearings)
DOI: 10.1520/F2162-01E02
ASTM International is a member of CrossRef.