Historical Standard: ASTM F1674-05 Standard Test Method for Joint Restraint Products for Use with PVC Pipe
SUPERSEDED (see Active link, below)
Active (view current version of standard)
1.1 This test method describes a procedure for qualifying the performance of joint restraint products for use on PVC pressure pipe systems by evaluating the effect of the joint restraint product on the performance characteristics of PVC pipe during cyclic pressure tests and static pressure tests. The PVC pipe property values referenced in this test method are for the 12454 compound as described in Specification D 1784. That includes, but is not limited to, pipe produced in accordance with the following standards: Specifications D 1785 and D 2241, AWWA C 900, and AWWA C 905.
1.2 This test method determines the short-term performance of a joint restraint product on PVC pipe, which involves the testing of restrained joint test sections to the minimum burst pressure requirements of the pipe to determine quick burst performance.
1.3 This test method determines the long-term effect of a joint restraint product on PVC pipe, which involves the testing of restrained joint test sections to the sustained pressure requirements of the pipe for a period of 1000 h.
1.4 This test method addresses restraint products that are rated at the full pressure capacity of the PVC pipe on which they are used. There are joint restraint devices available that are not rated at the full pressure capacity of the pipe. While those products have proven acceptable and useful in the marketplace, this test method does not apply to those products.
1.5 This test method determines the performance of a joint restraint product on PVC pipe subjected to cyclic pressure surges. The performance is compared to the baseline performance of pipe without joint restraint products established by Herbert W. Vinson.
1.6 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information purposes only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1784 Specification for Rigid Poly(Vinyl Chloride) (PVC) Compounds and Chlorinated Poly(Vinyl Chloride) (CPVC) Compounds
D1785 Specification for Poly(Vinyl Chloride) (PVC) Plastic Pipe, Schedules 40, 80, and 120
D2241 Specification for Poly(Vinyl Chloride) (PVC) Pressure-Rated Pipe (SDR Series)
D2837 Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials or Pressure Design Basis for Thermoplastic Pipe Products
F412 Terminology Relating to Plastic Piping Systems
AWWA StandardsAWWAC905 Polyvinyl Chloride (PVC) Pressure Pipe and Fabricated Fittings Pipe, Nominal Diameters 14 In. through 48 In. (350 mm through 1,200 mm), for Water Transmission and Distribution
cyclic surge pressure test; joint restraint for PVC; mechanical joint restraint for PVC pipe; Vinson equation; Joints (pipe/tube applications)--specifications; Poly(vinyl chloride)(PVC) pipe--specifications;
ICS Number Code 23.040.99 (Other pipeline components)