ASTM F1483-98
Historical Standard: ASTM F1483-98 Standard Specification for Oriented Poly(Vinyl Chloride), PVCO, Pressure Pipe
SUPERSEDED (see Active link, below)
ASTM F1483
1. Scope
1.1 This specification covers requirements for materials, dimensions, sustained pressure, accelerated regression testing, burst pressure, flattening, impact resistance, workmanship, and methods of marking for oriented poly(vinyl chloride) (PVCO) pipe for pressure applications.
1.2 The PVCO pipe shall be joined using elastomeric seals (gaskets). The joint shall meet the requirements of Specification D3139 and the elastomeric seal shall meet the requirements of Specification F477. The PVCO shall not be joined by solvent cementing.
1.3 The values stated in inch-pound units are to be regarded as standard. The values in parentheses are given for information only.
1.4 The following safety hazards caveat pertains only to the test method portion, Section 8 of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D883 Terminology Relating to Plastics
D1598 Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
D1599 Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings
D1600 Terminology for Abbreviated Terms Relating to Plastics
D1784 Specification for Rigid Poly(Vinyl Chloride) (PVC) Compounds and Chlorinated Poly(Vinyl Chloride) (CPVC) Compounds
D2122 Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
D2152 Test Method for Adequacy of Fusion of Extruded Poly(Vinyl Chloride) (PVC) Pipe and Molded Fittings by Acetone Immersion
D2444 Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
D2837 Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials or Pressure Design Basis for Thermoplastic Pipe Products
D3139 Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals
F412 Terminology Relating to Plastic Piping Systems
F477 Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe
Other Standards
PPI-TR 3 Policies and Procedures for Developing Recommended Hydrostatic Design Stresses for Thermoplastic Pipe Available from Plastics Pipe Institute, 1275 K St. N.W., Suite 400, Washington, DC 20005.Keywords
PVCO oriented polyvinyl chloride; pipe pressure ;
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/F1483-98
ASTM International is a member of CrossRef.