ASTM F1445-00
Historical Standard: ASTM F1445-00 Standard Test Method for Determining Static Thermal Sensitivity of Direct Thermal Paper
SUPERSEDED (see Active link, below)
ASTM F1445
1. Scope
1.1 This test method covers the static thermal response of direct thermal papers to determine uniformity within and between lots. This test method can also be used to test other direct thermal products with substrates other than paper.
1.2 The instrument described in this test method may be used for specification acceptance, product development or research applications, or both, but its primary use is for manufacturing control.
1.3 The values stated in either inch-pound or SI units are to be regarded separately as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ANSI Standard
IT2.17-1995 Density Measurements Geometric Conditions for Reflection Density Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
direct thermal media (paper, film, and paper/film laminate); static thermal response; static thermal response curve; Direct thermal imaging; Static tests--paper products/applications; Thermal process/properties; Thermal transfer imaging systems;
ICS Code
ICS Number Code 37.100.20 (Materials for graphic technology)
DOI: 10.1520/F1445-00
ASTM International is a member of CrossRef.