ASTM F1247-89(2005)
Historical Standard: ASTM F1247-89(2005) Standard Specification for Intrusion Resistant Generic Vault Structures
SUPERSEDED (see Active link, below)
ASTM F1247
1. Scope
1.1 This specification is for the use and guidance of those who purchase, design, construct, install, approve, or modify generic vault structures intended for protection of valuables against loss due to forced entry.
1.2 This specification includes the descriptions of terms, classifications, materials, practices, and methods to be followed in constructing, fabricating, or modifying intrusion resistant generic vaults.
1.3 This specification does not address fire resistivity, nor does it address modular panels.
1.4 This specification is not intended to prevent the use of systems, methods, or devices that provide a level of intrusion resistance equivalent or better than that prescribed herein. Any system, method, or device different from that detailed herein may be examined, in accordance with the intent of this specification, and if found to be equivalent or better, may be included.
1.5 Nothing in this specification shall be construed to prohibit better or safer conditions than the requirements specified herein.
1.6 Materials and construction details outlined in this specification are intended to detail protective requirements necessary to achieve the required level of intrusion resistance, and are not intended to address structural soundness or operational fitness, areas for which the project engineer, architect, or equipment supplier are responsible.
1.7 Each referenced document cited in Section 2 shall be meant to be the edition in effect on the date this specification was published. Note 1A rationale is given in Appendix X1.
1.8 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.9 The following precautionary statement pertains to the test method portion only, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A184/A184M Specification for Welded Deformed Steel Bar Mats for Concrete Reinforcement
A615/A615M Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement
A635/A635M Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural, High-Strength Low-Alloy, and High-Strength Low-Alloy with Improved Formability, General Requirements for
F1090 Classification for Bank and Mercantile Vault Construction
Keywords
intrusion deterrence; intrusion resistance; vault; vault construction; vault structure; Classification; Generic vault structures; Grids; Security systems and equipment--specifications; Vaults ;
ICS Code
ICS Number Code 13.310 (Protection against crime)
DOI: 10.1520/F1247-89R05
ASTM International is a member of CrossRef.