ASTM F1173-01
Historical Standard: ASTM F1173-01 Standard Specification for Thermosetting Resin Fiberglass Pipe Systems to Be Used for Marine Applications
SUPERSEDED (see Active link, below)
ASTM F1173
1. Scope
1.1 This specification covers reinforced thermosetting resin pipe systems with nominal pipe sizes (NPS) 1 through 48 in. (25 through 1200 mm) which are to be used for all fluids approved by the authority having jurisdiction in marine piping systems.
1.2 Values stated in inch-pound are to be regarded as the standard. Values given in parentheses are for information only.
1.3 The dimensionless designator NPS has been substituted for traditional terms as 'nominal diameter,' 'size,' and 'nominal size.'
1.4 The following safety hazards caveat pertains to the test methods which are included in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D883 Terminology Relating to Plastics
D1598 Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
D1599 Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings
D2105 Test Method for Longitudinal Tensile Properties of Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Tube
D2310 Classification for Machine-Made Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe
D2584 Test Method for Ignition Loss of Cured Reinforced Resins
D2924 Test Method for External Pressure Resistance of Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe
D2992 Practice for Obtaining Hydrostatic or Pressure Design Basis for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings
D3567 Practice for Determining Dimensions of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings
D5028 Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis
D5686 Specification for Fiberglass(Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type Epoxy Resin, for Condensate Return Lines
E1529 Test Methods for Determining Effects of Large Hydrocarbon Pool Fires on Structural Members and Assemblies
F412 Terminology Relating to Plastic Piping Systems
Keywords
epoxy resin fittings; epoxy resin pipe; marine piping; nominal pipe size; thermoset epoxy resin pipe;
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/F1173-01
ASTM International is a member of CrossRef.