ASTM D6369-99
Historical Standard: ASTM D6369-99 Standard Guide for Design of Standard Flashing Details for EPDM Roof Membranes
SUPERSEDED (see Active link, below)
ASTM D6369
1. Scope
1.1 This guide covers the design of details for typical conditions encountered in new ballasted, mechanically attached or fully adhered ethylene propylene diene terpolymer (EPDM) sheet roof systems.
1.2 This guide illustrates general details for typical conditions that may be encountered on an EPDM sheet roofing system. The guide will assist the designer in preparing details for each specific condition that may occur on a project.
1.3 The values stated in SI units are to be regarded as the standard. The conventional units given in parentheses are provided for information purposes only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1079 Terminology Relating to Roofing and Waterproofing
Keywords
EPDM; expansion joint; flashing; parapets; roof drain;
ICS Code
ICS Number Code 91.100.50 (Binders. Sealing materials)
DOI: 10.1520/D6369-99
ASTM International is a member of CrossRef.