ASTM D5657-01
Historical Standard: ASTM D5657-01 Standard Test Method for Fluid Tightness Ability of Adhesives Used on Threaded Fasteners
SUPERSEDED (see Active link, below)
ASTM D5657
1. Scope
1.1 This test method covers the determination of the ability of adhesives used for locking and sealing threaded fasteners, to make leak-tight assemblies.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Federal Specification
FF-N-836 Nut: Square, Hexagon, Cap, Slotted, Castle, Knurled, Welding and Single Ball Seat Available from U.S. Government Printing Office Superintendent of Documents, 732 N. Capitol St., NW, Mail Stop: SDE, Washington, DC 20401, http://www.access.gpo.gov.ASTM Standards
D907 Terminology of Adhesives
SAE Standard
SAEJ429 Mechanical and Material Requirements for Externally Threaded Fasteners Available from Society of Automotive Engineers (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.Keywords
adhesive; fluid tightness; sealing; threadlocking;
ICS Code
ICS Number Code 83.180 (Adhesives)
DOI: 10.1520/D5657-01
ASTM International is a member of CrossRef.