ASTM D3657-03
Historical Standard: ASTM D3657-03 Standard Specification for Zipper Dimensions
SUPERSEDED (see Active link, below)
ASTM D3657
1. Scope
1.1 This specification establishes standard dimensions for zippers of all materials for specified size designation; for equivalency, in inch-pound and metric units, of zipper length and length tolerances, of tape width and width tolerances, and of tape end lengths.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D123 Terminology Relating to Textiles
D2050 Terminology Relating to Fasteners and Closures Used with Textiles
D2060 Test Methods for Measuring Zipper Dimensions
Keywords
dimensions; specifications; zippers; Dimensions; Textile fabrics/fibers--specifications; Zippers--specifications;
ICS Code
ICS Number Code 61.040 (Headgear. Clothing accessories. Fastening of clothing)
DOI: 10.1520/D3657-03
ASTM International is a member of CrossRef.