ASTM D2259-02
Historical Standard: ASTM D2259-02 Standard Test Method for Shrinkage of Yarns
SUPERSEDED (see Active link, below)
ASTM D2259
1. Scope
1.1 This test method is used to determine the shrinkage of yarns in skein form when treated in boiling water, dry heat, saturated steam, or solvents. This test method is applicable to yarns made from any fiber or combination of fibers where the tex of the yarn is known or can be determined. This test method is not recommended for elastomeric yarns and those yarns that stretch more than 5 % under the tension loadings prescribed, although it has been used for the latter.
Note 1Procedures for determining yarn shrinkage and bulk properties of textured yarns are covered in Test Method D 4031.
1.2 This test method shows the values in both SI and inch-pound units. 'SI' units is the technically correct name for the system of metric units known as the International System of Units. 'Inch-pound' units is the technically correct name for the customary units used in the United States. The values stated in either SI units or in other units shall be regarded as standard. The values expressed in each system may not be exact equivalents; therefore each system must be used independently of the other without combining in any way.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D123 Terminology Relating to Textiles
D1059 Test Method for Yarn Number Based on Short-Length Specimens
D1776 Practice for Conditioning and Testing Textiles
D1907 Test Method for Linear Density of Yarn (Yarn Number) by the Skein Method
D2258 Practice for Sampling Yarn for Testing
D3888 Terminology for Yarn Spinning Systems
D3990 Terminology Relating to Fabric Defects
D4031 Test Method for Bulk Properties of Textured Yarns
D4848 Terminology Related to Force, Deformation and Related Properties of Textiles
D4849 Terminology Related to Yarns and Fibers
E145 Specification for Gravity-Convection and Forced-Ventilation Ovens
Keywords
dimensional change; shrinkage; yarn; Diameter--textile fabrics/fibers; Shrinkage--textile fabrics/fibers; Yarn properties ;
ICS Code
ICS Number Code 59.080.20 (Yarns)
DOI: 10.1520/D2259-02
ASTM International is a member of CrossRef.