ASTM D1505-03
Historical Standard: ASTM D1505-03 Standard Test Method for Density of Plastics by the Density-Gradient Technique
SUPERSEDED (see Active link, below)
Translated Standard: Russian , Spanish
more info
ASTM D1505
1. Scope
1.1 This test method covers the determination of the density of solid plastics.
1.2 This test method is based on observing the level to which a test specimen sinks in a liquid column exhibiting a density gradient, in comparison with standards of known density.
Note 1The comparable ISO document is ISO 1183-2. There has not been any data generated to date comparing the results of the ISO method with this method.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D883 Terminology Relating to Plastics
D2839 Practice for Use of a Melt Index Strand for Determining Density of Polyethylene
D4703 Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO Standard
ISO 1183-2 Methods for Determining the Density and Relative Density of Noncellular Plastics Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.Keywords
density; film; gradient; plaque; polyolefins; polyethylene; polypropylene; preparation; Density--plastics; Density-gradient technique;
ICS Code
ICS Number Code 83.080.01 (Plastics in general)
DOI: 10.1520/D1505-03
ASTM International is a member of CrossRef.