ASTM D1101-97a
Historical Standard: ASTM D1101-97a Standard Test Methods for Integrity of Adhesive Joints in Structural Laminated Wood Products for Exterior Use
SUPERSEDED (see Active link, below)
ASTM D1101
1. Scope
1.1 These test methods cover an accelerated means of measuring the resistance to delamination of structural laminated wood members intended for exterior service.
1.2 Two test methods are included. Choice of test method depends on purpose of the test and available time to complete.
1.2.1 Test Method A- This test requires 3 days to complete and is a method for determining the suitability of glues and manufacturing techniques and equipment for production of joints adequate for exterior service.
1.2.2 Test Method B- This test requires approximately 12 1/2 h. (If excessive delamination occurs, the cycle is repeated). It is a quality-control type test for examining glue joint quality.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D907 Terminology of Adhesives
D2559 Specification for Adhesives for Bonded Structural Wood Products for Use Under Exterior Exposure Conditions
Other Standards
ANSI/AITCA190.1&ndas Wood Products - Structural Glued Laminated TimberKeywords
exterior use; glulam; laminated wood; structural-glued-laminated timber; structural laminated wood;
ICS Code
ICS Number Code 83.180 (Adhesives)
DOI: 10.1520/D1101-97A
ASTM International is a member of CrossRef.